Overview; Serial Interface Specification; Transfer Specification; Connection - Sanyo PLC-XF1000 - 12000 Lumens Manual

PLC-XF1000 Expand Serial Command Functional Specifications
1． Overview
・ This Functional Specification defines communication with Network board for PLC-XF1000.
・ Commands are designed to communicate with Network board, but most commands are also
available to remote-control a projector through RS-232C from a computer. Therefore, commands
are defined as Expand Serial Commands.
・ The operation by some commands depends on Optional Board installed in Input Slot of the
projector.
・ This document assumes that Option Boards are installed.
2． Serial Interface Specification

2.1 Transfer Specification

Items
Synchronous System
Transmission Speed
Data Length
Parity
Stop Bit
Flow Control
1) Transmission Speed: initial setting value is 19200
2) Transmission Speed can be changed in Service Mode

2.2 Connection

Dedicated serial cables that come with a projector must be used for the connection between a
computer and the projector.
Connect COM port of the computer to SERIAL PORT IN of the projector.
COM Port (COM1 or COM2) of a computer is specified by control software of the computer.
Asynchronous
9600 / 19200
8 bit
N/A
1
N/A
PC
COM 1
（D-Sub 9 Pin）
8/72
Specification
Projector
Serial Port IN
（D-Sub 9 Pin）