Cf_Gamma Command; Cf_Nzred Command; Cf_Progv Command - Sanyo PLC-XF1000 - 12000 Lumens Manual

PLC-XF1000 Expand Serial Command Functional Specifications

8.4.12 CF_GAMMA Command

Command "CF_GAMMA_%1" [CR]
"000-015" ---------------- Directly specify setting value of Gamma
%1 "UP"---------------------- Increment setting value of Gamma by 1
"DN"---------------------- Decrement setting value of Gamma by 1
Set user controlled value of Gamma. (Available only in the normal Power ON
status)
Details The value set by this command is not stored in the projector's memory. Therefore,
when the power is turned to ALL OFF status, the value returns to the original
setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable

8.4.13 CF_NZRED Command

Command "CF_NZRED_%1" [CR]
"ON" ------------------------------Set Noise Reduction to ON
%1
"OFF" ---------------------------- Set Noise Reduction to OFF
Set or Cancel Noise Reduction. (Available only in the normal Power ON status)
The value set by this command is not stored in the projector's memory.
Details
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable

8.4.14 CF_PROGV Command

Command "CF_PROGV_%1" [CR]
"ON" ------------------------------ Set Progressive scan to ON
%1 "FILM" ---------------------------- Set Progressive scan to Film mode
"OFF" ---------------------------- Set Progressive scan to OFF
Set or Cancel Progressive scan. (Valid only when it is in the normal Power ON
status.)
Details The value set by this command is not stored in the projector's memory. Therefore,
when the power is turned to ALL OFF status, the value returns to the original
setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
22/72