Enterasys Gold Distributed Forwarding Engine 4G4205-72 Hardware Installation Manual page 67

Table 4-1 LANVIEW LEDs (continued)
LED Color
CPU Off
Amber
Green
Red
Green and
Amber
Amber and
off
RX/TX Indications in Standard Mode
RX Off
(Receive)
Green
Amber
Red
State
Power off.
Blinking. DFE module in
process of booting.
Solid. Testing.
Blinking. Image starts
running.
Solid. Functional.
Solid. Processor in reset.
Blinking. Indicates that the
DFE module is in the process
of shutting down.
Alternately (67% on, 33%
off). Indicates that a
shutdown process has
completed. This indication
will remain for 60 seconds
before automatically
restarting.
No link. No activity. Port
enabled or disabled.
Solid. Link present, port
enabled, no traffic is being
received by the interface.
Flashing. Link present, port
enabled, traffic is being
received by the interface.
Blinking. Indicates
collisions. This indication is
only supported on 10/100
ports.
Enterasys Matrix DFE-Gold Series PoE Module Hardware Installation Guide 4-5
Recommended Action
Ensure chassis has adequate power.
None.
If the LED remains amber for several
minutes, contact Enterasys Networks
for technical support.
None.
None.
None.
None. This state is activated when the
OFFLINE/RESET switch is pressed for
less than 1 second to start the process
of an orderly shutdown.
While in this state, do not remove any
DFE module.
While in this state, you have 60
seconds to safely remove the DFE
module from the chassis.
None.
None.
None.
Contact Enterasys Networks for
technical support.
Using LANVIEW