Deleting A Workgroup - Enterasys ATX User Manual

3. In the Ports in Workgroup area, click on the check boxes corresponding to
4. Click on Add. The new workgroup entry will be added into the Workgroup
5. Repeat steps 1-5 to set up any additional workgroups.

Deleting a Workgroup

Highlight the workgroup you would like to delete in the Workgroup Table. Click
on Delete, the highlighted workgroup will be deleted. To have this change
reflected in the workgroup table, click on Apply. The currently defined
workgroups will be displayed.
Configuring a Workgroup
• IP Address — you must enter a network IP address for the member
ports' subnetwork. If the subnet identifier of the received packet's
destination IP address matches the set workgroup IP address (when
compared to any set IP Mask), the packet will only be forwarded to the
other member ports of the workgroup.
• IP Mask — If your network uses a complex subnetting scheme (in
which the host identifying portion of the IP address is not subnetted on
the byte boundary), you can enter the IP Mask identifying hosts within
the subnetwork.
b. If you choose IPX as your workgroup type, you can enter a specific IPX
Network Address to use as a match for incoming broadcast packets. The
IPX Network Address is a 4 byte hexadecimal value that has been
assigned to the IPX network. If you leave the IPX Network Address blank,
this workgroup will be considered the default IPX workgroup.
the ports you would like to include in this workgroup. Each port is identified by
index number, interface type, and interface speed. Note that you cannot select
Port 1 (the Network Management PPP port) for inclusion into a workgroup.
table.
Workgroup Configuration
5-5