Enterasys ATX User Manual page 21

The Module Menu
There is one module menu selection:
•
The PPE Port Menu
The port representing the ATX's Packet Processing Engine (PPE) has the following
selections in its port menu:
•
The Port Menu
The port menu selections are as follows:
•
•
•
•
•
•
•
Port Status Displays
When you open the Chassis View window, each port on the ATX Switch will
display its Admin status (defined below); to change this status display, select one
of the options on the Port Status menu, as described in the following sections.
Viewing Chassis Information
Module Type..., which brings up a window containing a description of a
module inserted in the ATX Switch; see
Description..., which brings up a window describing the selected port; see
Interface Description,
Description..., which brings up a window describing the selected port; see
Interface Description,
I/F Stats..., which graphically displays the traffic passing between your
bridged networks; see Chapter 3.
Admin Enable/Disable, which administratively turns the selected bridging
port on or off; see Administratively Enabling and Disabling
for more information.
IPX Routing, which allows you to enable or disable IPX Routing on any of the
interfaces on the ATX; see
IP Config/Routing, which allows you to enable any port in your ATX Chassis
for IP routing; see IP Routing,
Port Configuration, which allows you to configure each individual port for
broadcast protection, ring speed (for token ring ports only), and local
switching (for token ring and fast ethernet ports only); see
on page 2-16.
Bridge Configuration, which allows you to configure bridging parameters on
an individual port basis; see
Viewing Hardware
page 2-11.
page 2-11.
IPX Routing, page
page 2-14, for more information.
Bridge Port Configuration,
The ATX Switch Chassis View
Types, page
Ports, page
2-12, for more information.
Port Configuration
page 2-17.
2-10.
2-29,
2-7