Checking Cabinet For Squareness - Craftsman 113.198210 Owner's Manual

CHECKING CABINET FOR SQUARENESS
TOOLS NEEDED: Framing square, 3/4" wrench
and 7/16" wrench or socket.
1 With cabinet on back side place a square on
lower shelf next to right side panel, Adjust stand
so both right side panel and lower shelf touch
square (as illustrated) Then tighten nut holding
rear of shelf to side panel and right side spacer to
front of lower shelf Repeat procedure for left
side,
i , , i, i i,,, rlH"' ,ill i,ilrl :
2 PIace square at top side of cabinet and adjust
stand so square touches both skirt and side
panel (as illustrated) Then tighten right side of
front and rear skirts to side panel, Repeat pro-
cedure for left side°
3, Locate four (4) leveling and eight (8) !/2-13 hex
nuts Attach the leveling feet to bottom of side
panels in front and rear as illustrated, Hand
tighten hex nuts.
WARNING: TO AVOID INJURY FROM UNEXPECT-
ED SAW OR WORK MOVEMENT, LEVELING FEET
MUST BE ADJUSTED SO THAT SAW DOES NOT
ROCK. TO AVOID UNEXPECTED CARRIAGE MOVE-
MENT, ADJUST LEVELING FEET SO THAT THE
ARM SLOPES SLIGHTLY DOWNWARD TO THE
REAR.
4. To adjust leveling feet so the saw will set properly:
a Move saw to desired location
b, With 3/4" wrench loosen bottom nut,
c. Back off top nut by hand
d Raise or lower foot by adjusting bottom nut
using 3/4" wrench,
e, Snug top nut against inside of leg by hand,
f, Adjust all four feet as necessary, then tighten
all four bottom nuts using a 3/4" wrench
t4