Checking Blade Squareness To Table; Assembling Steel Legs - Craftsman Contractor 113.29884 Owner's Manual

CHECKING BLADE SQUARENESS TO
TABLE
IMPORTANT: BLADE must be SQUARE {90 °) to
TABLE, in order to proceed wilh assembly,
1. Turn ELEVATION handwheel clockwise unti!
blade is up as high as it will go.
2. Check for BLADE SQUARENESS _. if blade is
not square to table, adjust it at this time.
NOTE: The combination square must be "true" -
see start of "Unpacking and Checking Contents"
section for checking method used to check
sq LJare
Refer to "BLADE TET, OR SQUARENESS OF BLADE
TO TABLE" in the "'ADJUSTMENT" section of this manual
for instructions on how to sauare blade to table.
MAKE SURE SQUARE
!S NOT TOUCHING
TIP OF TOOTH
/
ASSEMBLING STEEL LEGS
From among the loose parts, find the following Hard-
ware:
24 Truss Head Screws, 1/4-20 x 1/2 in. long (top of
screw is rounded)
24 Lockwashers, 1/4 in. External Type (approx. dia.
of hole 1/4 in.)
24 Hex Nuts, 1/4-20 (approx. dia. of hole 1/4 in.)
8 Hex Nuts, 3/8-16 (approx. dia. of hole 3/8 in.)
4 Leveling Feet
1/4-20 x 1/2 IN.
TRUSS HEAD SCREW
Q
1/4-20
HEX NUT
©
1/4 IN. LOCKWASHER
3/8-16
HEX NUT
LEVELING FEET
Assemble the legs as shown:
1 Insert the Truss Head Screws through the holes in
the legs, then through the holes in the stiffeners.
MAKE SURE THE SCREWS GO THROUGH THE
HOLES IN THE SIDE STIFFENERS MAKED "X".
2. Install the Iockwashers. Screw onthe nuts but do not
tighten until completely assembled.
3. Install leveling feet.
4. Adjust leveling feet as follows:
A. Move saw to desired location.
B. With 9/16 inch wrench loosen bottom nut.
C. Back off top nut by hand.
D. Raise or lower foot by adjusting bottom nut using
9!16 inch wrench.
E. Snug top nut against inside of leg by hand.
F. Tighten all fourbottom nuts using 9/16 inchwrench,
E.o l
STIFFENER F"
1/4-20 x 1/2 IN.
_ TRUSS
HEAD
i SCREW
1/4 IN.
LOCKWASHER, _,,. 3/8 IN. HEX NUTS
_-- LEVELING FOOT
14