Rip Lock Adjustment - Craftsman 113.198210 Owner's Manual

2, With a 3/16 inch hex "L" wrench find the 1/4-20
hex socket cap screwthrough the hole in the rear
arm cover To tighten turn the wrench clockwise
approximately 1/4 turn
3 Lock the miter lock handle and try again to move
the arm Readjust if necessary
4, If it becomes extremely difficult to push the miter
lock handle into the locked position too much
adjustment has been made Turn the wrench
counterclockwise one half the amount of the last
adjustment and try again to lock the arm
RIP LOCK ADJUSTMENT
The rip lock handle locks the carriage in any position
along the length of the track If the carriage can be
easily moved by pushing and pulling on the yoke
handle when the rip lock handle is in the locked
position an adjustment is required
1. Hold the rip lock handle in the unlocked position
and with a 7/t6 inch wrench tighten the 1/4-20
hex lock nut 1/4 turn as illustrated
2 Lock the rip lock handle and try again to move
the carriage Make additional adjustments if
necessary,
3 Now place the rip lock handle in the unlocked
position and move the carriage back and forth
from stop to stop If the carriage is difficult to
move at any point or you can feel the rip lock
dragging on the track the adjustment is too tight,
Loosen the hex nut one half the amount of the
last adjustment and try again
ARM TRACK
L_/
SPRING
LOCKNUT
RIP LOCK _'_ ..... /" "'-_\'
LEVER CAM
CARRIAGE
BOLT
42