Table of Contents
Advertisement
3.
If the insert is BELOW the table surface, remove the
insert and bend the tabs (with pliers) enough to make
the insert ABOVE the table surface.
4.
To replace insert.
Place insert into
insert opening
in table and push
toward
rear of saw to engage spring clip and until
keyslot in insert wi!l drop over screw. Tighten screw.
DO NOT TIGHTEN
SCREW TO THE POINT WHERE IT
DEFLECTS THE INSERT.
CHECKING BLADE SQUARENESS TO TABLE
IMPORTANT:
BLADE
must be SQUARE
(90 °)
to
TABLE, in order to proceed with assembly.
1. Turn ELEVATION
handwheel clockwise until blade is
up as high as it will go.
2. Check for BLADE SQUARENESS
. . . if blade is not
square to table, adjust it at this time.
NOTE:
The Combination
Square must be "TRUE"-
See start of "Unpacking
and Checking Contents section
on page 6 for checking method.
Refer
to
"BLADE
TILT,
OR SQUARENESS
OF
BLADE TO TABLE" adjustments on page 24.
CHECKING BLADE ELEVATION
Maximum depth of cut MUST NOT EXCEED TWO AND
ONE HALE
(2-1/2 INCHES. This adjustment
iS set at the
factory
and should be checked to make sure that it has not
changed due to rough handling during shipment.
With the blade up as high as it will go, measure the distance
from the top of the table to top of the highest saw tooth. If
it is more than two and one half (2=1/2) inches, adjust it at
this time. Refer to "BLADE
ELEVATION"
adjustments on
page 26.
ATTACHING
TABLE EXTENSIONS
If
you
received
two
Table
Extensions
with
your saw
(furnished
with Model No. 113.295750)
attach them at this
time.
1. Position saw upside down on floor.
NOTE;
To protect
the finished
surfaces of the saw and
extensions, lay a piece of heavy paper on the floor.
2,
From
among the
loose
parts
find
the
following
hardware:
6 Hex Head ,_crew_6/16.
--
18 × 1 in.
long
6 Lockwashers, 5/16 in. External Type
(approx: die; of hole 5/16 in,)
6 Flat Washers (dia. of hole 11/32 in.)
6 Hex Nuts, 5/16 - 18 (approx. die. of hole 5/16 in.)
3.
Install
screws, wasbars_ and nuts for
extensions
as
shown..,
tighten screws SLIGHTLY.
BE SURE END OF EXTENSIONS
ARE EVEN WITH
FRONT EDGE OF SAW.
4.
Leave saw in upside down position until you attach the
rip fence guide bars and legs.
\
i
f
iii
FLAT WASHER
LOCKWASHER
MAKE
SURE SQUARE
IS NOT
TOUCHING
TiP OF
TOOTH
SCREW
$
Hide quick links:
Advertisement
Table of Contents
