Shutdown Command - Enterasys Security Router X-PeditionTM User Manual

Table A-7 Medium Severity Alarms/Events (continued)
Module Message
ETH0_ PHY write operation unsuccessful
DRIV
DIAL Dial muxIoctl call fail
DIAL Modem on intf # is not responding
DIAL Invalid init string for modem on intf #
DIAL Number busy for modem on intf #
DIAL No dial tone for modem on intf #
DIAL No carrier for modem on intf #
DIAL No answer for modem on intf #
DIAL Connection dropped for modem on intf#s
DIAL Hangup fail for modem on intf #
DIAL Connection closed for modem on intf #
DIAL Dialup connection opened for modem on
intf #
CLI Failed to create session for Telnet access
CLI Unrecognized parameter <parameter
string> at line <line #> in <file>
FR serial a/b:d, started
FR serial a/b:d, shutting down
FR serial a/b:d, station up, DLCI nnn
FR serial a/b:d, unknown LMI message
FR Serial a/b:d, dlci nn, No InVArp response
from remote
FR Max. packet size based on CIR,BC,BE is
less than 1514 bytes
Refer to the table below for all Low severity alarms and events reported by the XSR. All of the
following messages are USER_LEVEL facility except for those in
SECURITY_LEVEL.
Table A-8 Low Severity Alarms/Events
Module Message
T1E1 Receiver has Loss of Signal (Red Alarm).
T1E1 LOS alarm on receiver cleared.
Description
The PHY chip on the FastEthernet 1 interface has had an error (other
than time-out) while processing a write request. When this occurs, port
functionality may or may not be affected. The port will still be available,
but its functionality may be diminished. The cause of this alarm is most
likely HW failure.
Failure of the serial driver of the physical port connected to the
modem.
The modem is not connected or powered on.
The modem does not recognize the initialization string. You should
check the modem specification for a proper setup.
The remote site dialed number is busy.
There is no dial tone for the modem PSTN line.
The remote modem is not present at the site called by the local
modem.
The remote modem is not configured for autoanswering.
The phone line connection is disconnected by the PSTN.
Failure of the disconnect from the phone line command to the modem.
The phone line disconnect command is successful.
The modem has successfully built a phone line link with the remote
site.
Telnet session could not be created at this time.
Invalid parameters from initialization configuration file during boot
process. This file is different from the startup.cfg.
Result from no shutdown
Shutdown command
Cannot decode the received LMI Message.
The remote peer is not responding to Inverse ARP requests.
Description
Indicates that T1/E1 physical port is detecting LOS Alarm.
Indicates that T1/E1 physical port is not detecting LOS Alarm.
System Alarms and Events
command
text which are
bold
XSR User's Guide A-11