Enterasys Security Router X-PeditionTM User Manual page 431

Table A-7 Medium Severity Alarms/Events (continued)
Module Message
T1 ERROR: Shared memory allocation failed
for Receive Descriptors.
T1 T1E1 PCI Init Failed.
T1 ERROR: Shared memory allocation failed
for Transmit Pending Queue.
T1 ERROR: Shared memory allocation failed
for Transmit Done Queue.
T1 ERROR: Shared memory allocation failed
for Transmit Descriptors.
T1 ERROR: Shared memory allocation failed
for Receive Free Queue.
T1 ERROR: Shared memory allocation failed
for Receive Done Queue.
T1 ERROR: Shared memory allocation failed
for Receive Descriptors.
SNTP SNTP request receive-timeout.
SNMP SNMP auth failure from <ip address>
<community>
SNMP SNMP <trapType> trap. No route to host
<IP address>
SNMP CLI config mode locked by SNMP user
%s\n
SNMP CLI config mode released by SNMP user
%s\n
SNMP SNMP <trapType> trap dropped due to
queue overflow
SNMP No SNMP host is defined, traps are
queued
SNMP SNMP <trapType> trap dropped when
trying to send, cause unknown
SNMP SNMP <trapType> trap. No route to host
<ip address>
PPP PPP CHAP authentication failed while
authenticating remote peer's response
PPP PPP CHAP authentication failed while
being authenticated by remote peer
PPP PPP CHAP authentication success while
authenticating remote peer's response
PPP PPP CHAP authentication success while
being authenticated by remote peer
PPP PPP MS-CHAP authentication failed while
authenticating remote peer's response
Description
Error in allocating memory for T1E1 HW card.
Error in initializing T1E1 HW card.
Error in allocating memory for T1E1 HW card.
Error in allocating memory for T1E1 HW card.
Error in allocating memory for T1E1 HW card.
Error in allocating memory for T1E1 HW card.
Error in allocating memory for T1E1 HW card.
Error in allocating memory for T1E1 HW card.
Failure to receive reply time from the server after one second.
An SNMP request received with an invalid community name. The
community name with a maximum of 40 characters is displayed.
SNMP trap is added to retransmission queue because there is no
route to the SNMP target server
Process SNMP packet and begin to set values on a parameter under
config mode.
SNMP finished setting value on a parameter under config mode.
Too many traps are sent at a time causing the SNMP trap queue to
overflow. As a result, the oldest item in the trap queue was dropped.
An SNMP trap is enabled but the trap target server is not defined.
Failure to send an SNMP trap to the trap target server. The cause of
the failure is unknown.
An SNMP trap is added to the retransmission queue because there is
no route to the SNMP target server.
PPP CHAP authentication has failed while authenticating the remote
peer's response to the challenge.
PPP CHAP authentication has failed while being authenticated by the
remote peer.
PPP CHAP authentication has passed while authenticating the remote
peer's response.
PPP CHAP authentication has passed while being authenticated by
the remote peer.
PPP MS-CHAP authentication has failed while authenticating the
remote peer's response to the challenge.
System Alarms and Events
XSR User's Guide A-9