Lubrication; Maintenance Procedures; Table D- 6. Power Supply Connector J1; Figure D- 1. Stacker Control Board - Monarch 9820 Service Manual

9820/9830/9835 Service Manual

Table D- 6. Power Supply Connector J1

Connector J1 Pin
1 GND
2 N/C
3
4 N/C
5

Figure D- 1. Stacker Control Board.

LUBRICATION

The stacker should be lubricated whenever the idler
shafts are replaced.
NOTE: Do not get lubricant on stacker rollers or
belts; performance could be adversely
affected.
1. Turn stacker and printer off.
2. Remove stacker from knife assembly.
3. Remove the stacker rear and side covers.
4. Apply silicon lubricant to the two bearing on the
rear frame and two bearings on the front frame.
See Figure D-2.
5. Replace the stacker covers.
6. Reattach stacker to knife.
7. Turn on printer and stacker and test for correct
operation.
62
Color
Black
White
TC9830SM Rev. B 7/98 Confidential
On/Off Switch
AC Inlet

Figure D- 2. Stacker Lubrication Points.

MAINTENANCE
PROCEDURES
Use the illustrations provided and the Stacker
Illustrated Parts Breakdown for assistance in
performing maintenance. Maintenance procedures for
the stacker are described below.
Note the following general safety reminders before
servicing the stacker. Additional Warnings and
Cautions are provided where appropriate as they
apply to specific procedures.
WARNING
Never perform maintenance on the stacker with the
power cord connected. Doing so exposes points
where AC voltages are present. Reattach power cord
only when test procedures indicate that power is
required.
CAUTION
Static electricity can damage stacker parts. Use a
static ground wrist strap.
Model 928 Stacker
To
Bearings
July 1998