Power Transformer Assembly; Transformer Removal; Bridge Rectifier Removal; Ac Inlet Removal - Monarch 9820 Service Manual

9820/9830/9835 Service Manual
POWER TRANSFORMER
ASSEMBLY
Maintenance of the Power Transformer involves
removing/reassembling the power
transformer.
removing/reassembling the bridge rectifier.
removing/reassembling the AC Inlet.
TOOLS REQUIRED:
Longnose Pliers
Phillips Screwdriver

Transformer Removal

CAUTION
You must remove several wires from the Bridge
Rectifier, AC Inlet module, and the Control Board
Assembly power connector. It is crucial to reconnect
the wires properly when replacing the transformer.
Connection
to AC Inlet
Bridge Rectifier
Transformer

Figure 6-1. Transformer Wiring Diagram

1. Remove four bridge rectifier wires as shown in
Figure 6-1.
2. Remove power connector CN6 from the Control
Board Assembly. (See Appendix C for location of
connectors.)
3. Remove six transformer wires from the AC Inlet
module.
4. Remove four transformer base screws.
5. Lay the two grounding wires aside so they do not
snag when replacing the transformer.
6. Remove the transformer.
28
CN6
TC9830SM Rev. B 7/98 Confidential
7. Reassemble in reverse order.

Bridge Rectifier Removal

Figure 6-2 Bridge Rectifier (Four Wires)

CAUTION
The bridge rectifier has four wire connections. See
Figure 6-2. Reconnect the black and red wires
properly when replacing these wires or the printer
could be damaged (voltages vary).
1. Remove the four wires and single retainer screw
located in the center of the rectifier.
2. Remove the bridge rectifier.
3. Reassemble in reverse order.

AC Inlet Removal

6-3 . Bridge Rectifier (Four Wires)
The AC Inlet has six wires coming from the
transformer and one ground wire. Reconnect the wires
properly when replacing this part (voltages vary).
Service Procedures
July 1998