Table Of Contents - Craftsman 351.219071 Instruction Manual

UNPACKING AND CHECKING CONTENTS
This mortiser will require some amount of assembly.
Three L handle allen wrenches (8mm, 6mm and 5mm)
and one T handle allen wrench (4mm) are provided for
assembly.
Remove all protective materials and coatings from the
parts. The protective coatings can be removed by
spraying WD-40 on a part and wiping it off with a soft
cloth. This may need to be redone several times before
all of the protective coatings are removed completely.
CAUTION: DO NOT use acetone, gasoline or lacquer
thinner to remove any protective coatings.
After cleaning, apply a good quality automotive wax to
any unpainted surfaces. Make sure to buff out the wax
before assembly.
Remove all of the parts from the shipping box and lay
them on a clean work surface. Compare the items to
Figure 3 and verify that all items are accounted for
before discarding the shipping box.
To avoid serious injury, do not attempt to plug in the
power cord and turn "ON" the morfiser if any parts are
missing. The morfiser should only be turned "ON" after
all the parts have been obtained and installed correctly.
The following items and hardware are to be provided in
the shipping box:
Figure 3
Ill
30
29
26 25
I
24
27
28
®
©
5
1. Mortiser
2. Spacer Block
3. Raise / Lower Handle
4. Fence Assembly
5.5mm L-Handle Allan Wrench
6.6mm L-Handle Allen Wrench
7. 8mm L-Handle Allen Wrench
8. Chuck Key
9 4mm T-Handle Allen Wrench
10. Long Fence Lock Handle
11. Short Fence Lock Handle
12. (4) M8 Lock Washers
13. (4) M8 Flat Washers
14. (4) M8 x 30mm Hex Head Screws
15. (4) M8 x 80mm Hex Head Screws
16. Base
17. Micro Adjust Assembly
18. Lower Ball Stud Fitting
19. (2) M4 x 8mm Pan Head Screws
20. (2) M4 Flat Washers
21. Support Bar
22. Tool and Chisel Holder
23. Hydraulic Cylinder
24. Hold Down
25. Spring
26. Shoulder Bolt
27. Guide Rod
28. 1/2" Mortising Chisel and Bit
29. 3/8" Mortising Chisel and Bit
30. 5/16" Mortising Chisel and Bit
31. 1/4" Mortising Chisel and Bit