Advertisement
Available languages
Available languages
ON-OFF
SWITCH
The switch is located on the side of the motor, To turn
the machine on flip the switch up to the "ON" position,
To turn the machine off, move the switch down to the
"OFF" position.
Figure
21
When the tool is not in use, the switch should be locked
in the "OFF" position to prevent unauthorized use. This
can be done by grasping the switch toggle (A) and
pulling it out of the switch.
With the switch toggle
removed, the switch will not operate.
Should the toggle
be removed while the machine is running, the switch
can be turned off once, but cannot be restarted without
inserting the switch toggle. See Figure 21.
RAISING
AND LOWERING
THE HEAD
DEPTH STOP ROD
Figure
23
B
D
The depth stop rod is provided to limit the depth of the
chisel.
See Figure 23.
Figure
22
1.
To adjust the depth stop rod (A), loosen set screw
(B) using provided 4mm T handle allen wrench.
2.
Lower head until the chisel(C) is at the desired
depth.
B
3.
Lower depth stop rod until it contacts the base (D).
4.
Tighten set screw.
The head is raised and lowered by using the lever. For
maximum leverage during the mortising operation, the
lever can be repositioned by pulling out the hub (A) of
the lever assembly and repositioning hub on the pinion
shaft (B). See figure 22.
16
Advertisement
