Advertisement
Available languages
Available languages
ASSEMBLING
CHISEL AND BIT
Figure 17
Make sure that the machine is disconnected from the
power source.
Chisels are very sharp and can cause a serious cut.
Take extreme caution when handling chisels.
Figure 15
A
\
\
\
\
\
\
\
\
G
I
/
1.
Insert bit (A) into chisel (B). See Figure 15.
B
,
Lower chisel 1/16" to 3/16" and tighten set screw.
There must be a space of 1/16" to 3/16" clearance
(G) between the bushing (H) and shoulder of
chisel (I) as shown in Figure 17. This assures
having proper clearance between the cutting edges
of the bit and points of the chisel after the bit is
inserted into the chuck.
Figure 16
,f
[
/
Figure 18
K
,
Loosen set screw (C) and push chisel (D) up
through hole in head (E) as far as possible, making
sure that the opening in the chisel (F) is facing to
the left or right. See Figure 16.
,
14
Push bit (J) up through the chisel and into the
chuck (K) as far as it will go and lock bit into chuck
using the supplied chuck key. See Figure 18.
Advertisement
