Craftsman 351.219071 Instruction Manual page 19

ATTACHING COLUMN EXTENSION
The column can be extended for the purpose of mortis-
ing taller workpieces
Make certain the machine is disconnected from the
power source.
Figure 28
,
,
,
Snap off the hydraulic cylinder (G) and remove the
lower junction screw (H). See Figure 29.
Remove the 4 M8 x 30mm Hex Head screws (I)
and remove the mortiser column (J) from the
base (K).
Remove the 4 M8 Lock Washers and 4 M8 Flat
Washers from the 4 M8 x 30mm Hex Head screws
and put them on the 4 M8 x 80mm Hex Head
Screws.
F
C
Figure 30
,
,
,
4.
Remove the 2 M4 x 8mm Pan Head Screws (A)
that fasten the MJcroAdjust Assembly (B).
See Figure 28.
Loosen Lock Knob (C) and remove micro adjust
assembly from the Fence Glide Shaft (D).
Remove Short Fence Lock Handle (E).
Slide Fence Glide Shaft completely out of the
mortiser column (F).
Figure 29
K
,
,
10.
11.
12.
13.
19
Line up the holes in the spacer block (L) with the
holes in the base. See Figure 30.
Place mortiser column over the spacer block and
fasten to base using the 4 M8 x 80ram Hex Head
Screws, 4 M8 Lock Washers and 4 M8 Flat
Washers.
Reinstall lower junction screw and attach hydraulic
cylinder.
Slide Fence Glide Assembly into the hole in the
Spacer Block.
Thread Long Fence Lock Handle (M) into spacer
block.
Place Micro Adjust Assembly over the Fence Glide
Shaft and fasten to the mortiser column using the
2 M4 x 8mm Pan Head Screws and 2 M4 Flat
Washers.