13 Troubleshooting; Onboard Administrator Error Messages - HP Integrity Superdome 2 User Manual

13 Troubleshooting

Onboard Administrator error messages

The error message types are:
Soap Response Errors: These are the general errors reported by the gSoap service for validation
errors, device failures, and so on. These errors are organized into the following categories:
◦ User Request errors
◦ Onboard Administrator errors
Soap interface errors: These signal internal problems with the actual gSoap service itself.
CGI application errors: These are errors reported by individual CGI processes. Each one issues
its own set of errors:
◦ File upload errors
◦ Insight Display screen shot errors
Onboard Administrator errors
1 The submitted user already exists.
2 The submitted user name is not valid.
3 The maximum number of users already exists.
4 A system error occurred while creating the submitted user.
5 The requested user does not exist.
6 The submitted group already exists.
7 Invalid privilege level.
8 Insufficient privileges for the requested operation.
9 The requested group does not exist.
10 The submitted user was already enabled.
1 1 The submitted user was already disabled.
12 The submitted user already has administrator rights.
13 The submitted user is not an administrator.
14 An error occurred while creating a group entry.
15 An error occurred while writing to the enclosure system log.
16 Could not fork a process.
17 An error occurred while reading the enclosure system log.
18 An error occurred while opening the requested blade's lockfile.
19 The submitted bay is already assigned.
20 The submitted bay is not assigned.
21 An error occurred while opening the requested blade's system log.
22 The submitted value is already in use.
23 The first character in the submitted value is not valid.
24 The submitted value contains an invalid character.
25 The submitted value is too short.
26 The submitted value is too long.
Onboard Administrator error messages 163