Cf_Keystone Command; Cf_Kystonmode Command; Cf_Ceil Command; Cf_Rear Command - Sanyo PLC-WM4500/L - 4500 Lumens Manual

PLC-WM4500/WM4500L Expand Serial Command Functional Specifications
8.7.7

CF_KEYSTONE Command

Command "CF_KEYSTONE _%1" [CR]
"UP" ------------- Correct Keystone distortion to reduce upper part of image
"FUP" ----------- Correct Keystone distortion to reduce upper part by 2 steps
%1 "DN" ------------- Correct Keystone distortion to reduce lower part of image
"FDN" ----------- Correct Keystone distortion to reduce lower part by 2 steps
"RST" ----------- Return Keystone and Corner to default setting
Change level of Keystone distortion correction (Available only in the normal
Power ON status).
When reached the limit of the correction level, projector accepts the command
but does not execute it. Receiving this command immediately invokes the
operation. When trying to set the value beyond available range, error code
Details
"201" is returned and the operation is not executed.
Example 1: When the correction level of the upper part has reached its limit
and then the command "UP" is received
Example 2: When the upper part correction allows only another step, and then
the command "FUP" is received.
Acceptable
Response
Unacceptable
8.7.8

CF_KYSTONMODE Command

Command "CF_KYSTNMODE _%1" [CR]
"STR" --------- Set Keystone store mode to Store
%1
"RST" --------- Set Keystone store mode to Reset
Set Keystone or Corner store mode
Details
(Available only in the normal Power ON status)
Acceptable
Response
Unacceptable
8.7.9

CF_CEIL Command

Command "CF_CEIL_%1" [CR]
"ON" --------------------------- Set Ceiling to ON.
%1
"OFF" ------------------------- Set Ceiling to OFF.
Set/Cancel Ceiling mode.(Available only in the normal Power ON status)
Details The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable

8.7.10 CF_REAR Command

Command "CF_REAR_%1" [CR]
"ON" --------------------------- Set Rear to ON.
%1
"OFF" ------------------------- Set Rear to OFF.
Set/Cancel Rear mode (Available only in the normal Power ON status)
When Rear is ON, projected image is left/right reversed.
Details
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
32/78