Bosch HGS246UC Use And Care Manual page 33

Freestanding gas range
Table of Contents

Advertisement

PROBLEM
The oven mode or
temperature
does not appear
in the display.
The oven door is locked and
will not release after self-clean
cycle.
The oven door is locked and
will not release, even after
cooling.
Oven is not heating.
Oven does not cook evenly,
food is undercooked
or food is
overcooked.
Oven light does not come on.
Oven light will not turn off.
Clock and/or
Timer are not
working properly.
POSSIBLE
CAUSE(S)
The knob was turned too rapidly.
Oven is too hot.
Oven door latch needs to be reset.
Oven temperature
is not selected.
Oven is not receiving proper
electrical
power.
Incorrect
rack position used.
SOLUTION(S)
Turn the knob slowly when selecting
a
mode or temperature.
Review manual
instructions
when setting the clock, the
timer or self-clean.
The oven door is designed to remain
locked after a self-clean cycle until a safe
temperature
is reached.
Turn the oven off at the circuit breaker
and wait five (5) minutes. Turn the oven
back on. The oven latch will be reset and
the door will open.
Verify that correct temperature
has
been selected.
Verify that the circuit breaker and/or
fuse box are working properly.
Verify hat
plug is completely
inserted into outlet.
Refer to recipe, package directions
or
cooking charts for proper rack position.
Oven calibration
is incorrect.
Adjust oven calibration
(See "Oven
Temperature
Offset", page 9).
Using convection
bake mode.
Bulb is loose, broken or burned
out.
Always reduce temperature
by 25 ° F when
using convection bake mode.
Verify that bulb is correctly
installed.
Replace broken or burned out bulb.
Note'- touching
the bulb with fingers may
cause it to burn out.
The oven light will not light during
This is normal. See Self-Cleaning
section.
the self-clean
mode.
This is normal. See Sabbath Node section.
The oven light cannot be changed
once the Sabbath mode has
started.
Oven door is not closing properly.
The oven light cannot be changed
once the Sabbath mode has
started.
ElecticaI power to range has been
interrupted.
Clock is set incorrectly.
Check for obstructions
between door and
range. Check for bent hinges.
This is normal. See Sabbath Mode section.
Check electrical connections.
Reset clock
after power is restored.
See "Setting the
Clock Time", page 6.
Reset clock time.
See "Changing the Clock
Time", page 6.
Page 30

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents