Ariens 992807-ProZoom 60 Owner's/Operator's Manual page 20

STARTING AND SHUT OFF
CAUTION: Read entire
,_ Owner/Operator Manual and
Engine Manual first. DO NOT
attempt to start the engine at this
time.
CAUTION: Always start and
,_ operate the engine in a well-
ventilated area. If in an enclosed
area, vent the exhaust outside.
To start the engine:
1. Sit properly in the seat, make sure the
steering controls are in the park position
and the PTO is off.
2. If the engine is cold, move the choke to
the On position. If the engine is warm,
do not use choke.
3. Move the throttle to the 3/4 fast position.
See Engine manual for detailed
instructions.
4. Put the key in the ignition switch and
turn it to the Start position. As soon as
the engine starts, release the key.
5. Move the choke control to the Off
position. Adjust the choke to keep the
engine running smoothly.
6. Allow the engine to warm for about five
minutes before operating the unit.
NOTE: Warming time will vary depending on
the ambient temperature. For temperatures
below 32 ° F (0 ° C), allow ten or more minutes
for the unit to warm.
7. Use the throttle to increase or decrease
engine speed. Set the throttle to the fast
position to cut grass.
To stop the engine:
1. Bring the steering levers to the neutral
position and disengage the PTO.
2. Move the throttle to the Slow position.
3. Turn the ignition key to the Off position.
Cold Weather Starting
NOTE: When starting in cold weather (below
-5 ° C (23 ° F)), do not run the starter more
than 10 seconds at a time. If the engine does
not start after 10 seconds allow the starter to
rest 30 seconds before trying again.
Stopping The Engine
Move the control levers to the park position,
idle the engine a few moments and turn the
ignition switch to the "Off" position. Remove
the key.
CAUTION: ALWAYS remove the
_l_ ignition key when the unit is not in
use.
STOPPING IN AN EMERGENCY
WARNING: Operating unit on slopes may lead to loss of
steering control. When operating
on slopes be prepared to react to
an emergency situation.
1. Return steering levers to neutral position
2. Immediately set parking brake
3. Turn off PTO and engine
ROLLOVER PROTECTIVE
STRUCTURE
,&
DANGER: AVOID INJURY[
Improperly installing or using
ROPS kits can lead to serious
injury or death. Read, understand
and follow all ROPS safety rules
in the owner/operator manual and
in the ROPS installation
instructions.
Do not weld, drill or alter the ROPS.
Damaged ROPS must not be straightened or
used. If damage does occur, contact your
Dealer and replace all damaged parts.
If the ROPS is lowered or removed from the
power unit for any reason, it must be raised
and/or reinstalled immediately. Original bolts
or equivalent replacements must be used and
tightened to the correct torque.
Do not attach chain, ropes, or cables to the
ROPS for pulling purposes as this will cause
the mower to tip backwards.
Ariens Company does not recommend the
use of the mower with the ROPS removed.
If you have a foldable ROPS, it can be folded
down for mower storage. It must be pinned in
the upright position prior to machine
operation.
SEAT BELT USAGE
With the ROPS installed, a seat belt must be
installed, used, and correctly adjusted at all
times. Replace damaged seat belts
immediately.
NEVER use a seat belt if operating with
ROPS folded down or removed.
GB - 20