Ariens 991056-Max Zoom 2560 Owner's/Operator's Manual page 16

Push L ever IntoDrive P osition
Pull Lever Out t othe Neutral Position
OF4105 Figure 5
©F4110
FOR BEST PERFORMANCE
Cut grass when it is dry.
Keep mower blades sharp.
Keep mower deck properly levelled.
Adjust anti-scalp rollers to prevent scalping.
Do not set height of cut too low. For very tall
grass, mow twice.
Do not travel too fast.
Mow with the engine set at full throttle.
When mulching, only remove 1/3 of grass
length per cutting. Do not cut more than 1
inch (2.54 cm) at any one time.
Discharge clippings into areas already cut.
Vary cutting pattern with each mowing.
Do not allow grass or debris to collect inside
of mower deck. Clean after each use.
WARNING: AVOID INJURY.
Read and understand entire
Safety section before proceeding.
Proper maintenance can prolong the life of
unit. The following charts show the
recommended service schedule. More
frequent service may be required due to
working conditions (heavy loads, high
ambient temperatures, dusty conditions, or
airborne debris).
See the maintenance instructions in the
Engine Manual for additional information.
GB - 16