Section 2. Details On Settings; References Of Firmware Versions; Settings Of Dip Switches - Epson T88IVP - TM Two-color Thermal Line Printer Application Manual

Section 2. Details on Settings

This section describes connection configurations and how to make the settings for the
TM-T88IV Series printers.

2.1 References of Firmware Versions

Refer to the release notes (Relnote.txt).

2.2 Settings of DIP Switches

Confirm that the following settings have been made correctly.
1) Serial port
DIP-SW1
No. Setting
1
2
3
4
5
6
7
8
It is possible to change the settings of DIP-SW1-1 (Processing of the data input
error) and DIP-SW1-2 (Specification of the received buffer capacity), but it is
recommended to leave them OFF.
Set DIP-SW1-3 (Handshake) to DTR/DSR.
Set DIP-SW1-4 (Bit length) to 8 bits.
Set DIP-SW1-5 to DIP-SW1-8 in accordance with the port information.
The described set values are the default values. For the details, refer to the
product manual of the POSPrinter. Also, if these settings are changed, make sure
to change the port information using the SetupPOS utility.
Set DIP-SW2-2 in accordance with whether or not a customer display is
connected. If connected, set to ON. If not, set to OFF.
OFF Recommended
OFF Recommended
OFF Fixed at OFF
OFF Fixed at OFF
OFF Settable
OFF Settable
ON Settable
OFF Settable
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-T88IV)
DIP-SW2
No. Setting
1 OFF
2 OFF
3 OFF
4 OFF
5 OFF
6 OFF
7 OFF
8 OFF
2
Version 2.65 Jul. 2009
Settable
Settable
Settable
Settable
Fixed at OFF
Fixed at OFF
Fixed at OFF
Fixed at OFF