Recovery Tank; Automatic Shut-Off; To Clean Filters - Hoover FloorMate SpinScrub Cleaner Manual

Recovery (lower) tank
Automatic shut-off
An automatic suction shut-off is built into the recovery
tank to prevent the tank from overflowing.
When the shut-off activates, the cleaner will not pick up
debris and the sound of the motor will change. The recov-
ery tank is full and must be emptied.
How to empty
Turn cleaner off and disconnect from electrical outlet.
Although not necessary for satisfactory performance, it is
recommended that the recovery tank be emptied after dry
vacuuming and before wet operation.
Check the solution tank also. It may need to be refilled at
this time.
To remove tank, press down on release button (B) and
pull tank straight out.
B
Remove tank lid (C). Empty tank.
To clean filters
The tank lid contains a washable, reusable filter. Clean this
filter when suction is low or reduced.
Turn cleaner off and disconnect from electrical outlet.
Q emove recovery tank and lid (Figs. 24 & 25). Remove
filter lid (A), then remove filter (B). Remove loose
debris from filter by tapping the filter or gently brushing
using your hand. The filter may also be rinsed for addition-
al cleaning. Allow filter to air dry between uses.
'A
B
J
J
Continued -_ 11