Dell B3460DN Mono Laser User Manual page 74

User guide
Hide thumbs Also See for B3460DN Mono Laser:
Table of Contents

Advertisement

Understanding the printer menus
Use
Timeouts
Prolong Screen Timeout
On
Off
Timeouts
Print Timeout
Disabled
1–255 sec
Timeouts
Wait Timeout
Disabled
15–65535 sec
Print Recovery
Auto Continue
Disabled
5–255 sec
Print Recovery
Jam Recovery
On
Off
Auto
Print Recovery
Jam Assist
On
Off
Print Recovery
Page Protect
Off
On
To
Display a message that lets you reset the screen timeout timer
instead of returning to the printer display.
Note: Off is the factory default setting.
Set the amount of time in seconds the printer waits to receive an
end‑of‑job message before canceling the remainder of the print
job.
Notes:
"90 sec" is the factory default setting.
When the timer expires, any partially printed page still in the
printer is printed, and then the printer checks to see if any
new print jobs are waiting.
Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print jobs.
Set the amount of time in seconds the printer waits for additional
data before canceling a print job.
Note: "40 sec" is the factory default setting.
Let the printer automatically continue printing from certain offline
situations when these are not resolved within the specified time
period.
Note: Disabled is the factory default setting.
Specify whether the printer reprints jammed pages.
Notes:
Auto is the factory default setting. The printer reprints
jammed pages unless the memory required to hold the
pages is needed for other printer tasks.
On sets the printer to always reprint jammed pages.
Off sets the printer to never reprint jammed pages.
Notes:
On is the factory default setting. On sets the printer to
automatically dump blank pages or partially printed pages to
the standard bin after a jammed page has been cleared.
Off requires the user to remove all pages from all possible
jam locations.
Successfully print a page that may not have printed otherwise.
Notes:
Off is the factory default setting. Off prints a partial page
when there is not enough memory to print the whole page.
On sets the printer to process the whole page so that the
entire page prints.
74

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents