Canon MP800 - PIXMA Color Inkjet Service Manual page 36

2 times absorbers
3 times or
Not valid
more
3) Press the ON/OFF button to proceed to the next step.
4) The waste ink amount can be set in 10% increments by pressing the Stop/Reset button. Press the Stop/Reset button the
appropriate number of time(s) to select the value which is closest to the actual waste ink amount.
Time(s)
0 times
1 time
2 times
3 times
4 times
5 times
6 times
7 times
8 times
9 times
10 times or more
5) Press the ON/OFF button to set the selected value to the EEPROM. Print EEPROM information to confirm that the value is
properly set to the EEPROM.
<LF correction procedures>
After replacement of the feed roller ass'y or logic board ass'y in repair servicing or in refurbishment operation, adjust the line
feeding.
1) In the LF correction mode, press the Stop/Reset button the specified number of times according to the paper to be used in LF
correction listed in the table below, then press the ON/OFF button.
Time(s)
1 time High Resolution Paper
2 times
3 times Plain paper
4 times
Note:
- The High Resolution Paper is the most desirable for LF correction printing (Canon HR-101 is used at the production site),
but 6 kinds of plain paper listed in the table above can also be used in LF correction. If plain paper other than the above is
used, select any one of the paper types in this step, then select Pattern No. 0 (zero) in the step 3) below.
- Each time the Stop/Reset button is pressed, the Alarm LED and the COPY button light alternately, Alarm in orange and
COPY in green.
- If the Stop/Reset button is NOT pressed, and only the ON/OFF button is pressed, the machine remains in the LF correction
mode.
- If the Stop/Reset button is pressed 5 times or more, then the ON/OFF button is pressed, the machine returns to the service
mode menu selection.
2) The LF correction pattern for the selected paper is printed.
Waste ink amount value to be set (%)
0%
10%
20%
30%
40%
50%
60%
70%
80%
90%
Not valid.
Press the ON/OFF button to return to the waste ink amount setting mode.
Paper type
Only the main waste ink absorber is valid for the MP800
Press the ON/OFF button to return to the waste ink
amount setting mode.
Paper name
Canon HR-101
Canon PB PAPER GF-500, Office Planner
HP BrightWhite, OFFICE 80
Canon Extra, STEINBEIS
1-31