Canon MP800 - PIXMA Color Inkjet Service Manual page 11

*1
continuable) .
Inner cover closed during
CD / DVD printing (print
*1
NOT continuable) .
Multiple ink tanks of the
same color installed.
Ink tank in a wrong
position.
Warning: The waste ink
absorber becomes almost
full.
The connected digital
camera or digital video
camera does not support
Camera Direct Printing.
Automatic duplex
printing cannot be
performed.
Failed in automatic print
head alignment.
The remaining ink
amount unknown.
Ink tank not recognized.
Ink tank not recognized.
Scanning unit (printer
cover) open.
*1: Only for models supporting CD / DVD printing
*2: Only for models not supporting CD / DVD printing
[1855]
More than one ink tank of the following color is
[1681]
installed. (U075)
Some ink tanks are not installed in place.
[1680]
(U072)
The waste ink absorber is almost full. Press
[1700]
[OK] to continue but early replacement
recommended. <See manual>
Incompatible device detected. Remove the
[2001]
device.
This paper is not compatible with duplex
[1310]
printing. Remove the paper and press [OK].
Auto head align has failed. Press [OK] and
[2500]
repeat operation. <See manual>
(Applicable ink tank icon)
[1683]
The remaining level of the following ink cannot
be correctly detected.
(Applicable ink tank icon)
[1684]
The following ink tank cannot be recognized.
(U140)
[1410 to (Applicable ink tank icon)
1419]
The following ink tank cannot be recognized.
(U150)
[1200] Cover is open. Close the cover.
button.
Open the inner cover, and press the OK
button to clear the error. The CD or DVD
being printed at error occurrence will be
ejected without printing the remaining
data for the ejected CD or DVD, then the
next print job will be done.
Replace the wrong ink tank(s) with the
correct one(s).
Install the ink tank(s) in the correct
position.
Press the OK button.
The service call error, indicating the
waste ink absorber is full, is likely to
occur soon.
Remove the cable between the camera
and the machine.
Press the OK button to eject the paper
being used at error occurrence. Printing
will resume from on the front side of the
next page. Data which was to be printed
on the back side of paper at error
occurrence is skipped (not printed).
Press the OK button.
- If paper is being fed at error
- If the error occurs, the print head
- After exit from the error by the
An ink tank which has once been empty
is installed. Replace the applicable ink
tank with a new one.
Printing with a once-empty or refilled
ink tank can damage the print head.
replacing the refilled ink tank, press the
Stop/Reset button for 5 sec. or longer to
record the use of a refilled ink tank.
Note:
After the above operation, the function to
detect the remaining ink amount is
disabled.
A non-supported ink tank is installed (the
ink tank LED is turned off). Install the
supported ink tanks.
An error occurred in an ink tank (the ink
tank LED is turned off). Replace the ink
tank(s).
Close the scanning unit (printer cover).
1-6
occurrence, the error is indicated after
the paper is ejected.
alignment values are not changed.
Stop/Reset button, the automatic print
head alignment will not be re-done.
If printing is continued without