[Punch Regist Loop Size Adjustment]; [Punch Edge Sensor Adjustment] - Konica Minolta bizhub C654 User Manual

Settings
[Adjust Value]
Tips
- Make adjustment while checking a sheet of paper having punched holes that are not in the correct po-
sitions.

[Punch Regist Loop Size Adjustment]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
- [Punch Regist Loop Size Adjustment]
If the positions of the punch holes on the paper are not in parallel with the paper edge, use this option to
correct the obliquity of the paper to make them parallel.
Settings
[Finisher]/[Finisher (Z-
Fold)]/[Post Inserter Feeder
Upper Tray]/[Post Inserter
Feeder Lower Tray]
[Paper Type]
[Adjust Value]
Tips
- Make adjustment while checking paper punched at a displaced position.

[Punch Edge Sensor Adjustment]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
- [Punch Edge Sensor Adjustment]
Use this option to adjust the sensor of the Punch function to detect the edge of the paper.
Press Start to start adjustment.
Tips
- This item is available if the Punch Kit PK-521 is installed in the optional Finisher FS-535.
bizhub C754/C654
Description
Enter an adjustment value between -5.0 and +5.0 mm by tapping [-] and
[+].
• [-]: Move the punch position to the left.
• [+]: Move the punch position to the right.
[0.0 mm] is specified by default.
Description
Select the position subject to paper inclination adjustment.
• [Finisher]: This item is available if Punch Kit is installed in the optional
Finisher.
• [Finisher (Z-Fold)]: This item is available if the Z Folding Unit is installed
in the optional Finisher FS-535.
• [Post Inserter Tray (Upper)]: This item is available if Punch Kit PK-521
and Post Inserter are installed in the optional Finisher FS-535.
• [Post Inserter Tray (Lower)]: This item is available if Punch Kit PK-521
and Post Inserter are installed in the optional Finisher FS-535.
Select the type of paper that is used to adjust the inclination.
Enter an adjustment value by tapping [-] and [+].
• [+]: Tap this key to adjust the inclination of the paper.
• [-]: Tap this key if it is not possible to adjust the inclination with [+] or
paper creases.
The available adjustment value is between -5.0 mm and 5.0 mm (other than
[Finisher (Z-Fold)] or between -16.0 mm and 16.0 mm ([Finisher (Z-Fold)]).
[0.0 mm] is specified by default.
17
17-17