4.1
General fax/scan operation
4
How to use Fax/Scan mode
This section describes the basic fax/scan operations in the enlarge display mode.
d
Reference
For details on the fax and scan operations, refer to the "User's Guide [Network Scan/Fax/Network Fax
Operations]".
4.1
General fax/scan operation
The following describes the general fax/scan operation.
0
Register addresses using the setting menu, and configure the fax and network settings and register
addresses in Administrator Settings in advance.
For details, refer to the "User's Guide [Network Administrator]" and the "User's Guide [Network
Scan/Fax/Network Fax Operations]".
1
Press the [Fax/Scan] key, and then the [Enlarge Display] key on the control panel.
The enlarged display screen for Fax/Scan mode appears.
2
Load the original.
For details on loading originals, refer to page 2-13.
3
Specify the destination.
% For details on specifying a destination, refer to page 4-5.
% If the destination was incorrectly specified, press the [C] (clear) key, and then specify the destination
again.
bizhub C652/C652DS/C552/C552DS/C452
4
4-2