General Fax/Scan Operation - Konica Minolta bizhub C280 User Manual

4.1

General fax/scan operation

4 How to use Fax/Scan mode
This section describes the basic fax/scan operations in the enlarge display mode.
d
Reference
For details on the fax and scan operations, refer to the [User's Guide Network Scan/Fax/Network Fax Oper-
ations].
4.1 General fax/scan operation
The following describes the general fax/scan operation.
0 Register addresses using the setting menu, and configure the fax and network settings and register ad-
dresses in Administrator Settings in advance.
For details, refer to the [User's Guide Network Administrator] and the [User's Guide Network
Scan/Fax/Network Fax Operations].
1
Press the Fax/Scan key, and then the Enlarge Display key on the Control Panel.
The enlarged display screen for Fax/Scan mode appears.
2
Load the original.
For details on loading originals, refer to page 2-14.
3
Specify the destination.
% For details on specifying a destination, refer to page 4-4.
% If the destination was incorrectly specified, press the C (clear) key, and then specify the destination
again.
bizhub C360/C280/C220
4
4-2