Error Message List - Konica Minolta bizhub C452 Function Manual

10.1

Error message list

10 Appendix
10.1 Error message list
If an error message appears, perform the corresponding operation described below.
Message
Unable to connect to the net-
work.
The address for the communi-
cation method cannot be select-
ed since the number of
addresses has exceeded the
maximum allowed for broad-
casting.
Document could not be saved in
user box due to insufficient HDD
capacity. Check log
The number of registered user
boxes has reached the maxi-
mum allowed.
The number of documents
saved in the User Box has
reached its maximum
The number of programmed job
has reached the max. allow-
ance. Wait until a programmed
job is completed.
d
Reference
For details on the network settings, refer to "User's Guide [Network Administrator]".
bizhub C652/C652DS/C552/C552DS/C452
Cause and remedy
Make sure that the network cable is correctly connected. In addition,
make sure that "Network Settings" in "Administrator Settings" have
been correctly configured.
The number of destinations specified exceeds the number possible
for a broadcast transmission. Reduce the number of broadcast desti-
nations, or send the transmission in multiple batches.
The hard disk is full. Delete unnecessary data, and then try saving the
data again.
The number of User Boxes that can be registered has reached the
maximum number possible. Delete unnecessary User Boxes, and
then try registering new boxes again.
The number of documents that can be saved in a User Box has
reached the maximum number possible. Delete unnecessary docu-
ments, and then try saving the document again.
The number of jobs that can be programmed has reached the maxi-
mum number possible. Wait until a job has been completed, or delete
a current job.
10
10-2