Printer Setup; Page Count - Lexmark E238 Service Manual

Printer setup

Defaults
Selections are U.S. or Non-U.S. This selection affects the following defaults:
Printer setting
Default paper size*
Envelope size*
Fax paper size
PCL Symbol Set
PPDS code page
Units of measure
* Where input sources do not have size sensing capabilities.
Warning: Changing this setting resets the printer to factory defaults and
data may be lost. It cannot be undone.

Page Count

Reset the page count when an engine card is replaced.
To reset the page count:
1. Select Page Count from the PRINTER SETUP menu.
Page Count
=1234567*
2. The leftmost number blinks. Use Menu to increase or decrease the
number, and press Select to move to the next digit to the right.
Continue until the correct number displays. To skip a number without
changing it, press Select.
When Select is pressed after the last digit, the number is saved.
Perm Page Count (permanent page count)
The permanent page count can only be viewed and cannot be changed.
To view the permanent page count:
1. Select Perm Page Count from PRINTER SETUP.
2. Press Return to return to PRINTER SETUP.
U.S. value
Letter
10 Envelope
Letter
PC-8
437
Inches
Diagnostic aids—E340 and E342n
4511-xxx
Non-U.S. value
A4
DL Envelope
A4
PC-850
850
Millimeters
3-29