Mounting The Remote Core Processor - Emerson MICRO MOTION 2700 Installation Manual

Installing the Transmitter
To mount the transmitter/core processor assembly:
1. Identify the components shown in Figure 2-6. For dimensions, see Appendix A.
2. If desired, re-orient the transmitter on the bracket.
a. Loosen each of the four cap screws (4 mm).
b. Rotate the bracket so that the transmitter is oriented as desired.
c. Tighten the cap screws, torquing to 30 to 38 in-lbs (3 to 4 N-m).
3. Attach the mounting bracket to an instrument pole or wall. For pipe mount, two user-supplied
U-bolts are required. Contact Micro Motion to obtain a pipe-mount installation kit if required.
Figure 2-6 Transmitter/core processor assembly – Exploded view
Core processor
Core processor housing
Conduit opening
for 9-wire cable
Mounting bracket
2.5

Mounting the remote core processor

Note: This step is required only for remote core processor with remote transmitter installations (see
Figure 2-1). If you have an integral installation, 4-wire remote installation, or 9-wire remote
installation, go to Section 2.6.
If you chose the remote core processor with remote transmitter installation (see Figure 2-1), see
Figure 2-3 for a diagram of the mounting bracket supplied with the transmitter. Both pipe mounting
and wall mounting are shown.
Installation Manual
Transmitter
4 × Cap screws (4 mm)
End-cap
13