Chapter 1 Before You Begin; Overview; Safety - Emerson MICRO MOTION 2700 Installation Manual

Chapter 1
Before You Begin
1.1

Overview

This chapter provides an orientation to the use of this manual. This manual describes the procedures
required to install the following Model 1700 and 2700 transmitters:
• Model 1700 or Model 2700 with analog outputs option board
• Model 1700 or Model 2700 with intrinsically safe analog outputs option board
• Model 2700 with configurable input/outputs option board
• Model 2700 with F
• Model 2700 with PROFIBUS-PA option board
If you do not know what transmitter you have, see Section 1.4 for instructions on identifying the
transmitter type from the model number on the transmitter's tag.
Note: Installation information for Model 1500 transmitters or Model 2500 transmitters is provided in
a separate manual. See the manual for your transmitter.
1.2

Safety

Safety messages are provided throughout this manual to protect personnel and equipment. Read each
safety message carefully before proceeding to the next step.
Improper installation in a hazardous area can cause an explosion.
For information about hazardous applications, refer to the approval documentation,
shipped with the transmitter or available from the Micro Motion web site.
Hazardous voltage can cause severe injury or death.
Make sure power is disconnected before installing transmitter.
Improper installation could cause measurement error or flowmeter failure.
Follow all instructions to ensure transmitter will operate correctly.
Installation Manual
™
fieldbus option board
OUNDATION
WARNING
WARNING
CAUTION
1