The Telnet Screen - ZyXEL Communications NWA-1100 User Manual

Chapter 11 Remote Management
• You may only have one remote management session running at one time. The
ZyXEL Device automatically disconnects a remote management session of lower
priority when another remote management session of higher priority starts. The
priorities for the different types of remote management sessions are as follows:
Telnet
1
HTTP
2
System Timeout
There is a default system management idle timeout of five minutes (three
hundred seconds). The ZyXEL Device automatically logs you out if the
management session remains idle for longer than this timeout period. The
management session does not time out when a statistics screen is polling. You can
change the timeout period in the SYSTEM screen.

11.4 The Telnet Screen

Use this screen to configure your ZyXEL Device for remote Telnet access. You can
use Telnet to access the ZyXEL Device's Command Line Interface (CLI).
Click REMOTE MGNT > TELNET. The following screen displays.
Figure 50 Remote Management: Telnet
The following table describes the labels in this screen.
Table 29 Remote Management: Telnet
LABEL
TELNET
Server Port
Server
Access
104
You can change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Select the interface(s) through which a computer may access the ZyXEL
Device using Telnet.
DESCRIPTION
ZyXEL NWA-1100 User's Guide