Rip; Ppp - D-Link DSL-G604T User Manual

DSL-G604T 54Mbps Wireless ADSL2/2+ Modem/Router Manual
sections. For Service Filtering, the user must choose which services to be filtered by the router using
the corresponding check boxes. The user may choose any combination of these to use for firewalling.
Click Apply to set these firewall rules to the routers memory.

RIP

The DSL-G604T supports RIP v1 and RIP v2 used to share routing tables with other Layer 3 routing
devices on the LAN, at your ISP's location or remote networks connected to your network through the
ADSL line. The user may enable or disable RIP v1 (received and sent) or RIP v2. This will enable the
router to send and receive RIP packets. Disabling the RIP function will disable the routing function of
this device.
Figure 5- 10. RIP window
To configure RIP, first use the RIP pull-down menu to enable RIP on the Router. Then select the
protocol to be used by using the pull-down menu. The choices are RIP v1, RIPv1 Compatible and
RIP v2. Then the user must choose the direction by selecting In, Out or Both. After making the
configuration choices for RIP, click the Apply button to set the configurations in the memory of the
Router.

PPP

The following window is for users employing the PPP protocol as their connection to the ISP. This
window will be specific to PVCs previously configured and will display information concerning the
PVC selected in the WAN configuration window.
54