Power On Router; Factory Reset Button - D-Link DSL-G604T User Manual

Wireless adsl router

Hide thumbs Also See for DSL-G604T:

Table of Contents

Building Materials make a difference: Buildings constructed using metal framing or doors

can reduce effective range of the device. If possible, position wireless devices so that their

signal can pass through drywall or open doorways, avoid positioning them so that their signal

must pass through metallic materials. Poured concrete walls are reinforced with steel while

cinderblock walls generally have little or no structural steel.

Position the antennas for best reception. Play around with the antenna position to see if

signal strength improves. Some adapters or access points allow the user to judge the strength of

the signal.

Keep your product away (at least 1-2 metres) from electrical devices:

Position wireless devices away from electrical devices that generate RF noise such as micro-

wave ovens, monitors, electric motors, etc.

Power On Router

To power on the Router:

1. Insert the AC Power Adapter cord into the power receptacle located on the rear panel of the Router

and plug the adapter into a suitable nearby power source.

2. You should see the Power LED indicator light up and remain lit. The Status LED should light solid

green and begin to blink after a few seconds.

3. If you have the Router connected to your network you can look at the Ethernet Link/Act LED

indicators to make sure they have valid connections. The Router will attempt to establish the

ADSL connection, if the ADSL line is connected and the connection is properly configured this

should light up after several seconds.

The Router may be reset to the original factory default settings by depressing the reset button for 10

seconds while the device is powered on. Use a ballpoint pen or paperclip to push down the reset

button. Remember that this will wipe out any settings stored in flash memory including IP settings.

The factory default IP address of the Router is 10.1.1.1 and the subnet mask is 255.0.0.0.

DSL-G604T 54Mbps Wireless ADSL2/2+ Modem/Router Manual

Table of Contents