Add Static Routes To Your Router - TRENDnet TEW-718BRM User Manual

TRENDnet User's Guide

Add static routes to your router

Advanced > Static Route
You may want set up your router to route computers or devices on your network to
other local networks through other routers. Generally, different networks can be
determined by the IP addressing assigned to those networks. Generally speaking and for
the case of an example, your network may have 192.168.10.x IP addressing and another
network may have 192.168.20.x IP addressing and because the IP addressing of these
two networks are different, they are separate networks. In order to communicate
between the two separate networks, static routing needs to be configured. Below is an
example diagram where routing is needed for devices and computers on your network
to access the other network.
Note: Configuring this feature assumes that you have some general networking
knowledge.
© Copyright 2013 TRENDnet. All Rights Reserved.
1. Log into your router management page (see "Access your router management page"
on page 35).
2. Click on Advanced, and click on Static Route.
3. Next to Static Routing, check the Enable option to enable static routing.
3. Review the static route settings.
•
Destination – Enter the IP network address of the destination network for the
route.
(e.g. 192.168.20.0)
• Subnet Mask – Enter the subnet mask of the destination network for the route.
(e.g. 255.255.255.0)
• Gateway – Enter the gateway to the destination network for the route.
(e.g. 192.168.10.2)
• Hop – Enter the number of hops (routers) required to reach the destination
network. The hop count range that can be specified is 0-99.
•
Enable – Check the option to enable the route and uncheck the option to
disable the route.
4. To save changes, click Apply.
TEW-718BRM
50