Table of Contents
Advertisement
TRENDnet User's Guide
AP Only Mode
Setup > Wireless Settings
AP (Access Point) Only mode allows the modem router to function as a wireless access
point only. In this mode, wireless client devices connect to your network but will not be
assigned IP addresses automatically and cannot share Internet access. The device needs
to be interconnected from one of the four LAN ports (LAN 1-4) to one of the LAN ports
of another router which is configured for and connected to Internet. In addition, the
router must also be configured to assign IP addresses automatically. Please note that in
the diagram, the additional router can be wired or wireless. It is also recommended that
before using this mode, the modem router LAN IP address should be modified to an
available address within the range of the additional router (ex. 192.168.0.x, 192.168.1.x,
etc.) to ensure you are still able to access it's router management page after set up.
When enabling this mode, the modem router's DHCP server will be disabled
automatically.
Note: Please configure the modem router first, before connecting to any other routers.
Note: Please refer to
page 18
on configuring your wireless settings and
configuring your wireless security settings are configured first before using this mode.
1. Log into your router management page (see "Access your router management page"
on
page
35).
© Copyright 2013 TRENDnet. All Rights Reserved.
2. Click on Setup, and click on Wireless Settings.
3. Click the Wireless Operation Mode drop-down list and select AP Only Mode.
4. To save changes, click Apply.
Note: If you would like to discard the changes, click Undo before you click Apply.
5. If prompted to reboot in order to apply changes, click Reboot at the bottom of the
page and click OK or Continue to reboot the device.
6. Finally, connect one of the four LAN ports (LAN 1-4) to one of the LAN ports of your
additional router.
page 12
on
TEW-718BRM
25
Advertisement
Table of Contents
