Add Static Routes To Your Router - TRENDnet TEW-812DRU User Manual

TRENDnet User's Guide
3. Click on Enabled under Gaming Function section.
3. Review the virtual server settings. Click Apply to save settings.
• LAN IP Address: Enter the IP address of the device to forward the port (e.g.
192.168.10.101).
• TCP Ports to Open: Enter the TCP port you would like to set.
• UDP Ports to Open: Enter the UDP port you would like to set.
Note: Please refer to the device documentation to determine which ports and
protocols are required. You should assign a static IP address to the device or
use DHCP reservation to ensure the IP address of the device does not change.
• Schedule: Select the defined schedule you would like to have the rule to be
applied (see "Set Schedule" section on page 31).
• Enabled: Selecting Enabled turns on the virtual server and selecting unchecking
disables the rule.

Add static routes to your router

Advanced > Routing
You may want set up your router to route computers or devices on your network to
other local networks through other routers. Generally, different networks can be
determined by the IP addressing assigned to those networks. Generally speaking and for
the case of an example, your network may have 192.168.10.x IP addressing and another
network may have 192.168.20.x IP addressing and because the IP addressing of these
two networks are different, they are separate networks. In order to communicate
© Copyright 2013 TRENDnet. All Rights Reserved.
between the two separate networks, static routing needs to be configured. Below is an
example diagram where routing is needed for devices and computers on your network
to access the other network.
Note: Configuring this feature assumes that you have some general networking
knowledge.
1. Log into your router management page (see
on page 26).
2. Click on Advanced, and click on Routing.
3. Review the WAN Static Routes section. Click Apply to save settings.
• IP Address: Enter the IP network address of the destination network for the
route. (e.g. 192.168.20.0)
• Subnet Mask: Enter the subnet mask of the destination network for the
route.(e.g. 255.255.255.0)
• Gateway: Enter the gateway to the destination network for the route.
(e.g. 192.168.10.2)
TEW-812DRU
"Access your router management page"
36