Table of Contents
Advertisement
GS748T Software User Manual
Port Trunking is a feature that enables multiple links between switches to work as one virtual link
(aggregate link). Trunks can be defined for similar port types only. For example, a 10/100 port
cannot form a Port Trunk with a gigabit port. Trunks can only be formed within the same bank.
This page displays the Trunk status. The default Trunk setting is all groups disabled. To configure
user-defined Trunk groups, go to the Switch> Trunking page.
If the IEEE802.1Q VLAN is enabled, this page displays the VLAN tag status.
System Functions
Under the System heading in the Navigation Pane, there are four functions; click on any one to
enter the appropriate configuration screen:
•
Switch Status: Gives a snapshot of the current state of the switch.Click the
display the latest status information. As described above, this page appears by default when
you first login.
•
IP Access List: This page enables you to limit the IP addresses that can access the
management functions of the switch. The switch only responds to login requests from
computers whose IP addresses appear in its list. The Add button brings up a window into
which you can enter an IP address. When you have done so, click Apply. A typical view after
a few additions is shown below.
Figure 3-3
Click Delete to remove an entry.
3-6
v2.0, April 2007
button to
Refresh
Basic Web Management
Advertisement
Table of Contents
