Speaker Configuration; Input/Output Assign - Onkyo TX-NR626 Owner's Manual

Explanatory Notes
2. Speaker Setup

Speaker Configuration

■
Subwoofer
Yes
No
Main Menu
Sub Menu
Setting target
Setting options (default setting underlined)
Sub Menu
Main Menu

1. Input/Output Assign

Monitor Out
On the "Monitor Out" settings, you can select
whether or not to have the video sources' images
output through the HDMI output.
If you connect your TV to HDMI output, "Monitor Out"
setting is automatically set and composite video and
component video sources are upconverted
output.
Composite video,
component video
IN
OUT
Composite video,
component video
Note
• See "The video and audio signal flow"
charts showing how the "Monitor Out" and "Resolution"
settings affect the video signal flow through the AV
receiver.
■
Monitor Out
Main:
Select this if your TV is connected to HDMI OUT
MAIN.
Sub:
Select this if your TV is connected to HDMI OUT
SUB.
Both:
Select this if your TVs are connected to HDMI
OUT MAIN and HDMI OUT SUB. Video signals
are output from both HDMI outputs at the
resolution supported by both TVs.
En-53
Note
• The "HDMI Through" setting is only available for the HDMI
OUT MAIN jack
■
Resolution
Through:
Select this to pass video through the AV receiver
at the same resolution and with no conversion.
Auto:
Select this to have the AV receiver automatically
* and
convert video at resolutions supported by your
TV.
480p (480p/576p), 720p, 1080i, 1080p
HDMI
Select the desired output resolution.
4K:
Select this for an output resolution four times
that of 1080p. Depending on the resolution
supported by your TV, it will result in either 3840
× 2160 or 4096 × 2160 pixels.
HDMI
You can specify the output resolution for HDMI OUT
MAIN and have the AV receiver upconvert the picture
resolution as necessary to match the resolution
supported by your TV.
(➔ page 17) for
Tip
• You can see the picture by pressing ENTER to check the
"Resolution" setting for HDMI OUT MAIN (excluding NET,
USB and BLUETOOTH input source).
Note
• With some TVs, video signals are processed in the same
way as "Through" when this setting is set to "4K".
• If the "Monitor Out" setting is set to "Sub", this setting is
fixed to "Through".
• If the "Monitor Out" setting is set to "Both", this setting is
fixed to "Auto".
*1 When signal is 1080p input at 24 frames per second, it
will be 1080p output at 24 frames per second.
Advanced Operations
(➔ page 65).
:
*1
Operating
procedure
(➔ page 52)