Turning On & Basic Operations; Turning On/Off The Av Receiver; Connecting The Power Cord; Turning On - Onkyo TX-NR626 Owner's Manual

Turning On & Basic
Operations
Turning On/Off the AV
Receiver

Connecting the Power Cord

1 (Taiwanese models)
Connect the supplied power cord to the AV
receiver's AC INLET.
To AC wall outlet
2 Plug the power cord into an AC wall outlet.
Note
• Before connecting the power cord, connect all of your
speakers and AV components.
• Turning on the AV receiver may cause a momentary power
surge that might interfere with other electrical equipment on
the same circuit. If this is a problem, plug the AV receiver
into a different branch circuit.
• Do not use a power cord other than the one supplied with
the AV receiver. The supplied power cord is designed
exclusively for use with the AV receiver and should not be
used with any other equipment.
• Never disconnect the power cord from the AV receiver
while the other end is still plugged into a wall outlet. Doing
so may cause an electric shock. Always disconnect the
power cord from the wall outlet first, and then the AV
receiver.

Turning On

1
Press ON/STANDBY on the front panel.
or
Press RECEIVER followed by
the remote controller.
The AV receiver comes on and its display lights.
■
Smooth Operation in a Few Easy Steps
(Initial Setup)
To ensure smooth operation, here's a few easy steps
to help you configure the AV receiver before you use
it for the very first time. These settings only need to
be made once. See "Initial Setup" for details
(➔ page 22).
En-21

Turning Off

1
Press ON/STANDBY on the front panel.
or
Press RECEIVER followed by
the remote controller.
The AV receiver will enter standby mode. To
prevent any loud surprises when you turn on the
AV receiver, always turn down the volume before
you turn it off.
Tip
• The HYBRID STANDBY indicator may light depending on
the status of settings
• For details on power management settings, see "Auto
RECEIVER on
Standby" (➔ page
• If the HDMI Through setting is not set in standby mode, an
MHL-enabled mobile device cannot be charged even if it is
connected.
Turning On & Basic Operations
RECEIVER on
(➔ page 22).
66).