Download Print this page

Onkyo TX-NR579 Firmware Update

Av
Hide thumbs Also See for TX-NR579:

Advertisement

Firmware Update for TX-NR609/TX-NR579 and
HT-RC360
To update the firmware of the AV receiver, you can choose from the following two methods:
update via network, or update via USB storage. Choose the one that best suits your
environment. Before proceeding with the update, please read the corresponding explanations
carefully.
■Update via network (➔ page 2)
You need a wired Internet connection to update the firmware.
■Update via USB storage (➔ page 5)
Please prepare a USB storage device such as a USB flash memory stick. You need at
least 32 MB of available space to update the firmware.
Note
• Check the network connection before updating.
• Do not touch the any cable or device connected to the AV receiver during the update process.
• Do not attempt to access the AV receiver from your PC while it is being updated.
• Do not shutdown the power of the AV receiver while it is being updated.
• The storage media in the USB card reader may not work.
• If the USB device is partitioned, each section will be treated as an independent device.
• If the USB device contains a lot of data, the AV receiver may take a while to read it.
• Operation is not guaranteed for all USB devices, which includes the ability to power them.
• Onkyo takes no responsibility whatsoever for the loss or damage of data resulting from the use of a
USB device with the AV receiver. Onkyo recommends that you back up your important music files
beforehand.
• If you connect a USB hard disk drive to the USB port, Onkyo recommends that you use its AC adapter
to power it.
• USB hubs and USB devices with hub functions are not supported. Do not connect your USB device via
a USB hub.
• USB devices with security functions are not supported.
Limitation of liability
The program and accompanying online documentation are furnished to you for use at your
own risk. Onkyo will not be liable and you will have no remedy for damages for any claim of
any kind whatsoever concerning your use of the program or the accompanying online
documentation, regardless of legal theory, and whether arising in tort or contract. In no event
will Onkyo be liable to you or any third party for any special, indirect, incidental, or
consequential damages of any kind, including, but not limited to, compensation,
reimbursement or damages on account of the loss of present or prospective profits, loss of
data, or for any other reason whatsoever.
En
1

Advertisement

loading

Summary of Contents for Onkyo TX-NR579

  • Page 1 USB device with the AV receiver. Onkyo recommends that you back up your important music files beforehand. • If you connect a USB hard disk drive to the USB port, Onkyo recommends that you use its AC adapter to power it.
  • Page 2: Updating The Firmware Via Network

    ■ How to turn off HDMI Control(RIHD) Updating the Firmware via Network Press RECEIVER followed by SETUP The AV receiver allows you to update the on the remote controller. firmware using network connection on the rear Select “Hardware Setup” and press panel.
  • Page 3: Update Procedure

    ON/STANDBY on the front panel. RECEIVER on the remote Do not use controller. Once turned off, the AV receiver will automatically turn on again. Congratulations! You now have the latest firmware installed on your Onkyo AV receiver. (Go to the next page for troubleshooting.)
  • Page 4: Troubleshooting

    Then retry the update. Error Description Case 5: Code If you do not have an Internet connection, -10, The Ethernet cable was not please contact Onkyo Support (indicated in detected. Reconnect the cable the last page). properly. -11, -13, Internet connection error. -21, Check the following items: •...
  • Page 5 ■ How to turn off HDMI Control(RIHD) Updating the Firmware via Press RECEIVER followed by SETUP The AV receiver allows you to update the on the remote controller. firmware using a USB device. Select “Hardware Setup” and press Note ENTER. •...
  • Page 6 Connect a USB device to your PC. If ENTER. there is any data in the USB device, remove it first. Download the firmware file from the Onkyo web site. The file name is as follows: ONKAVR****_************.zip Unzip the downloaded file. The following three files are created: ONKAVR****_************.of1...
  • Page 7 Case 3: Congratulations! You now have the latest If an error occurs during the update process, firmware installed on your Onkyo AV disconnect then reconnect the AC power cord receiver. and try again. Case 4:...
  • Page 8 Unit 1033, 10/F, Star House, No 3, Salisbury Road, Tsim Sha Tsui Kowloon, Hong Kong. Tel: 852-2429-3118 Fax: 852-2428-9039 http://www.onkyochina.com/ Asia, Oceania, Middle East, Africa Please contact an Onkyo distributor referring to Onkyo SUPPORT site. http://www.intl.onkyo.com/support/local_support/index.html SN 29400869B (C) Copyright 2011 ONKYO SOUND & VISION CORPORATION Japan. All rights reserved. Y1106-3...

This manual is also suitable for:

Tx-nr609Ht-rc360