Controlling Other Components; Controlling Other Components Controlling Other Components; Preprogrammed Remote Control Codes; Entering Remote Control Codes - Onkyo TX-NR525 Owner's Manual

Controlling Other
Components
You can use the AV receiver's remote controller to
control your other AV components, including those
made by other manufacturers. This section explains
how to enter the remote control code for a component
that you want to control: DVD, TV, CD, etc.
Preprogrammed Remote Control
Codes
The following REMOTE MODE buttons are
preprogrammed with remote control codes for
controlling the components listed. You do not need to
enter a remote control code to control these
components.
For details on controlling these components, see the
indicated pages.
BD/DVD Onkyo Blu-ray Disc player
TV/CD Onkyo CD player (➔ page
PC Apple TV

Entering Remote Control Codes

You'll need to enter a code for each component that
you want to control.
1
Look up the appropriate remote control code
in the separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
2
While holding down the REMOTE MODE
button to which you want to assign a code,
press and hold down DISPLAY (about 3
seconds).
The remote indicator lights.
Note
• Remote control codes cannot be entered for
RECEIVER and the multi zone button.
• Only TV remote control codes can be entered for TV.
• Except for RECEIVER, TV, and the multi zone button,
remote control codes from any category can be
assigned for the REMOTE MODE buttons. However,
(➔ page 59)
these buttons also work as input selector buttons, so
58)
choose a REMOTE MODE button that corresponds
with the input to which you connect your component.
For example, if you connect your CD player to the CD
input, choose TV/CD when entering its remote control
code.
3 Within 30 seconds, use the number buttons to
enter the 5-digit remote control code.
The remote indicator flashes twice.
If the remote control code is not entered
successfully, the remote indicator will flash once
slowly.
Note
• Though the provided remote control codes are correct at
the time of release, they are subject to change.
En-57

Controlling Other Components

Remapping Colored Buttons

You can change the configuration of colored buttons,
with which REMOTE MODE buttons are preset.
1
While holding down the REMOTE MODE
button that you want to program, press and
hold down A (Red) until the remote indicator
lights (about 3 seconds).
You can only change colored buttons for
components whose codes belong to categories
of the Remote Control Codes list (BD/DVD
player, TV, cable set-top box, etc).
2 Within 30 seconds, press the colored buttons
in the order that you want to reassign them.
The button presses are assigned to each button
from left to right. The remote indicator flashes
twice, indicating that the sequence has been
successfully assigned. If the sequence is not
successfully assigned, the remote indicator will
flash once slowly.
Tip
• To reset the REMOTE MODE buttons to their default
settings, see "Resetting the REMOTE MODE Buttons"
(➔ page 58).
Note
• If any other button than the colored buttons is pressed, the
operation will be cancelled.
• This operation cannot be done while the AV receiver is in
Receiver mode or when Zone 2 is active.