Advanced Operations; On-Screen Setup; Using The Quick Setup - Onkyo TX-NR525 Owner's Manual

Advanced Operations

On-screen Setup

This section describes the procedure for using the
remote controller unless otherwise specified.
With the AV receiver connected to a TV, there are two
ways of changing the settings on-screen: using the
Quick Setup or the Setup Menu (HOME).
■
Quick Setup
The Quick Setup provides quick access to frequently
used settings. You can change settings and view the
current information.
■
Setup menu (HOME)
The Setup menu (HOME) provides a convenient way
to change the AV receiver's various settings. Settings
are organized into 11 categories.
Tip
• The on-screen menus appear only on a TV that is
connected to the HDMI OUT.
Note
• The on-screen menus are displayed when:
– There is no video input, or
– The video input is 480p, 576p, 720p, 1080i, or 1080p.

Using the Quick Setup

RECEIVER
ENTER,
/ / /
Q SETUP
1
Press RECEIVER followed by Q SETUP.
The Quick Setup will be superimposed on the TV
screen.
Q u i c k S e t u p
I n p u t
A u d i o
I n f o r m a t i o n
L i s t e n i n g M o d e
[ E N T E R : S e l e c t ]
2
Use / and ENTER to make the desired
selection.
Press Q SETUP to close the menu.
Press RETURN to return to the previous menu.
■
Input
You can select input sources and view information
on their assignments.
Use / to select an input source and view its
assignment information.
Pressing ENTER switches to the selected input
source.
En-41
■
Audio (➔ page
You can change the following settings: "Bass",
"Treble", "PM Bass", "Subwoofer Level",
"Center Level", "Audyssey", "Dynamic EQ",
"Dynamic Volume", "Late Night", "Music
Optimizer", and "Cinema Filter".
■
Information
*1
You can view the information of the following
items: "Input" and "Output".
■
Listening Mode
You can select the listening modes that are
RETURN
grouped in the following categories: "MOVIE/TV",
"MUSIC", "GAME".
Use / to select the category and
select the listening mode. Press ENTER to
switch to the selected listening mode.
Note
*1 Depending on the input source and listening mode, not
all channels shown here output the sound.
*2 • This setting is not available in either of the following
cases:
–The "Audio TV Out" setting is set to "On"
–"HDMI CEC (RIHD)" is set to "On"
you're listening through your TV speakers.
Explanatory Notes
■
PM Bass
Off
On
Setting target
Setting options (default setting underlined)

Advanced Operations

42)
*2
/ to
(➔ page 53).
(➔ page 52) and