The settings menu will be displayed.
2. Select Media Setup and press the Z button.
3. Use the d/u buttons to select Customize Settings and press the Z button.
4. Use the d/u buttons to select a media setting bank number between 1 and 30 and then
press the Z button.
Note that any settings already saved in the printer will be overwritten.
5. Use the d/u buttons to select Head Alignment and press the Z button.
6. Use the d/u buttons to select Manual(Uni-D) or Manual(Bi-D) and press the Z
button.
7. An alignment pattern will be printed.
When printing is complete, the media will automatically be fed to a position where the
pattern is clearly visible.
Cut the media if necessary. See "Cutting Media" on page 50.
Note:
To rewind the media, press the u button. Stop rewinding before the media is past the cutter
groove (on the pressure roller side).
If the leading edge of the media is curled, stop rewinding before the media reaches the
inner side of the front cover.
8. Check the pattern and select the pattern number that has the least gaps.
In the following example, this would be pattern number 2.
1
2
3
Basic Operations
72