Epson SureColor F7070 User Manual page 10

7 Auto switch
Use this switch to select the auto take-up direction. Choose Off to disable auto take-up.
8 Manual switch
Use this switch to select the manual take-up direction. The selected option takes effect when the Auto switch is in the Off
position.
9 Casters
There are two casters on each leg. Once installation is complete, the front casters should be kept locked while the printer is in
use.
10 Waste ink bottle (tank) holder
Place the waste ink bottle in this holder.
11 Adjuster
The adjusters keep the printer in place. After installing the printer, keep it securely in place during use.
12 Waste ink bottle (tank)
Waste ink collects in this bottle.
Replace with a new waste ink bottle when the level approaches the line.
13 Waste ink tube
Waste ink is discharged from this tube. Be sure the end of this tube is in the waste ink bottle while the printer is in use.
14 Ink tank
Holds ink used for printing.
15 Slider (chip holder)
See "Slider (chip holder)" on page 11.
16 Lock lever
Raise the levers to unlock the slider for removal when replacing the chip unit. Always lower the lock lever after inserting the
slider.
17 Chip unit check lamp
This lamp turns on when a message related to the chip unit is displayed.
On : An error occurred. Check the message on the control panel's screen.
Off : No error.
18 AC inlet
Connects the power cable.
19 LAN port
See "LAN port" on page 12.
20 USB port
Connects the USB cable.
21 Maintenance cover (right)
Open this cover to perform maintenance around the print head. Normally closed when using the printer.
See "Maintenance Around the Print Head" on page 84.
22 Media loading lever
After loading media, lower the media loading lever to keep the media in place. Raise the lever to release the media prior to
removal.
10
Introduction