Hitachi P50XR01E User Manual page 121

Attaching to the main unit
Warning
Please turn off the Main Power when the power code, the cables, and the speaker cables are being connected and
removed.
Ensure that the speakers are assembled after assembling the stand is completed.
Put the TV's packing material as below, and place the TV in its rear turning up.
Preparation
Take the accessories box out
with spreading the carton box.
Accesories box
Cushion (bottom)
Procedure for assembling the stand
1. Attach the braces to the stand unit
Attach the both braces to stand unit as shown bellow
picture.
Please ensure that holes for attaching the stand can
be seen form the stand unit.
holes for attaching the
stand
(back)
Packing box (bottom)
2 braces
stand unit
Lay TV face-down slowly.
Sheet covering TV
2. Secure the braces with screws
Install 4 screws to the both side from back of the stand.
Hexagonal
wrench
(back)
4 installation screws
(M6 x 25 screw)
3. Check again to ensure that the screws are
tightened firmly
Warning
Please ensure that screws are tightened firmly after the
braces are attached to the stand.
Failure to do so could cause the unit to tip over or
become damaged.
3
Rear of the
television