Carriage Unit Removal - Epson Stylus PHOTO 1270 Service Manual

EPSON Stylus Photo 870/1270

4.2.11 Carriage Unit Removal

1. Remove HOUSING. (Refer to Section 4.2.1)
2. Disconnect the head FFC from the printhead. (Refer to Section 4.2.4.)
3. Remove the Tension Spring 1.494 hanging SCALE, CR to the left side
of FRAME, TOP. Then remove SCALE, CR.
TENSION SPRING, 1.494
Figure 4-46. Remove the Tension Spring 1.491& CR Encoder Slit
4. Loosen the Timing Belt by pushing HOLDER, PULLEY, DRIVEN and
disengage the belt from the pulley of the CR motor. (Refer to Figure
4-20.)
Disassembly And Assembly
5. Push PULLEY, DRIVEN down and remove it from HOLDER, PULLEY,
SCALE, CR
6. Remove the Timing Belt from PULLEY, DRIVEN.
7. Remove LEVER, PG by releasing its hooks from the cutouts in the
Disassembly Procedures
DRIVEN.
HOLDER, PULLEY, DRIVEN
Figure 4-47. PULLEY, DRIVEN Removal
right side of FRAME, TOP. Then remove the LEVER, PG.
FRAME, TOP
Hooks
Figure 4-48. LEVER, PG Removal
Revision B
PULLEY, DRIVEN
LEVER, PG
105